Terp PivoTrap

This Is An Auto-spinner Mouthpiece 🤘😁 

This Is Also A Small Storage Container For Your ____ 

The Top & Bottom Chamber Are Completely Separated / Closed Off from each other

—————————

Both The Closed And Open Lid W The Mesh Screen Are Now Included  With Each Purchase! 

————————— 

* the stock lids are the black ones in the pics above. I’ll slowly roll out new lids that will work with the same mouthpieces 🤘😁 so anything new will work with what you already have 

—————————-

* leave the top chamber open & without a lid on and it’s a viewing window! You can see your pearls spin inside the pivot atomizer! 

 —————————
As A Pivot Mouthpiece - The Bottom Chamber

Gently push down and twist the tip in the pivot to make sure it’s attached

I cut and polished 2 slits, on opposite sides of each other, at angles that make them elite auto-spinner mouthpieces for the Pivot

 If you place 1 finger over one of the cut slits you can restrict the airflow a bit and cause the pearls to spin even faster 🤘😁 

Each Mouthpiece’s hole Is tested  to make sure 3mm pearls can’t fall out through them

The bottom chamber is attached the bent sipper straw

As A Whip Tip 

I made the  bottom a 10 female glass ground joint, which means that you can plug in anything with a 10 male ground joint into it, and use this as a glass mouthpiece 🤘😁 You can even use this as a glass mouthpiece for roll-ups

   HOW TO INSERT THE 10 MALE JOINT  Right Gently Until You First Feel Resistance. Gently pull back to Make Sure It’s locked in. Twist Left To Take Off.
—————

SAW CUT Slits VS blown out holes for superior Directional Airflow 

——————-----------------------------

The Top Chamber

I completely sealed off the top chamber from the bottom chamber attached to the mouthpiece. This means that nothing loaded into the chamber will fall through into the Pivot Chamber. I also made the top chamber with glass threads that fits a cap you can twist on to seal. This means that you can take the cap off, load the chamber, twist the cap back on - and not have to worry about anything falling out. 

Closed Lid = There’s no hole on this threaded cap, everything in the chamber is completely sealed off

Lid With Hole & Mesh Screen = Smell the Terps!  There’s a  hole in the middle of the lid on this threaded cap.  This is why I include a steel 1/2 inch mesh screen. After loading material in the top chamber, place the mesh screen on top of the glass, then screw the lid on. This screen will prevent the loaded material from falling out, while allowing access to smelling what’s inside